fold_and_go_three_speed
Fold and Go Three Speed
Watch You Tube Video
On how to assemble your Fold and Go Tricycle
http://www.youtube.com/watch?v=tVI4JA5SUGI

Assembly instructions for Fold and Go Tricycle

 

1 Remove tricycle from box

2 Remove all packaging and inspect for damage

3 Insert front wheel into fork

    Assemble as follows

    A) Insert wheel into fork, note brake arm is on right side and insearted int tab welded on fork.

    B) Insert safety washer into hole in fork

    C) Tighten axle nut on both sides of wheel

4 Attach front fender brace

5 Insert handlebar stem into fork and tighten lever on top of stem

 

   A) Note: Handlebar stem is marked with a minimum insertion mark

 

6 Insert seat post into frame

    A) Note seat pole is marled with a minimum insertion into frame mark

7 Install rear basket

    A) Put basket bolts thought basket and frame and tighten nut on bottom of bolt

8 Check air pressure in tires

    A) Air pressure is marked in side wall of tire

9 Inspect for safety before riding

   A) Brakes make sure they stop properly

   B) Handlebar stem and handlebar make sure they are tight

   C) Seat and seat post make sure it is tight

   D) Nuts on all three wheels are tight

   E) Check pedals to make sure they are tight

 

Trouble shooting

Front brake is not stopping properly

A)    Cable is too loose, use adjuster - thread outward

B)     If cable is still too loose adjust at cable anchor bolt by pulling wire through cable anchor bolt further

C)    Check to see if cable moves thought housing freely

D)    Check to see if brake handle does not bind

 

Three speed does not shift properly

A)    Adjust cable at adjuster barrel while in third gear- their should only be a little slack in the cable

B)    After adjuatment check to see that you can shift to third gear without forcing the shifter

C)    If cable is difficult to shift loosen cable slightly at adjuster barrel

 

Head Set (To loose or to tight)

A)    Loosen top nut, tighten or loosen cone by hand, retighten top nut with wrench

Rear wheel do not spin well

A) Nut on out side of wheel is to tight and binding bearing, loosen outside nut slightly